Question: Updates needed to DustDuino DIY wiki

apacheguy is asking a question about dustduino: Follow this topic

apacheguy asked on April 27, 2016 18:49
97 views | #13042


The wiki references an obsolete Arduino Proto Wireless Shield from Mouser that can no longer be purchased. Please update the wiki to suggest a working alternative solution.

The Arduino Uno + shield + wifi antenna is quite costly. Why not replace with a more robust and affordable Raspberry Pi 3? I assume that that one would still be able to connect the Groove sensor to the Pi 3 RX pins and read the output, no?



2 Comments

Hi, apacheguy - those sound like good suggestions; if you leave a comment on this original DustDuino note, Matthew Schroyer will get an email notification, and perhaps he'll make some updates!

https://publiclab.org/notes/Schroyer/11-23-2013/measure-coarse-and-fine-air-particulates-with-a-dustduino

Thanks!

Reply to this comment...


@apacheguy you may want to check out http://openpipekit.github.io/ for systems closer to what you describe!

Reply to this comment...


Log in to comment