What we want to do
We are setting up 24/7 observation stations to monitor gas refinery flares. This is a pilot program for a DIY observation station that is cheap, easy to construct, reasonably reliable, and produces usable data.
Please consider donating to fund development of our flare monitoring prototypes and tests by selecting the Donate button on the top of this page!
Why we are doing this
Do you drive by a refinery and wonder why that big flare is burning? What would you think if you were startled by what sounds like a jet landing in your yard and then you looked out the window to see a huge flame billowing black smoke? You would probably have health concerns and wonder how well the Department of Environmental Quality (DEQ) was doing their job.
Our objective is not to shut down refineries. We generally find the products they produce useful if not necessary. We want to make sure the refineries are working in the best interest of the health of the citizens and that DEQ is enforcing the regulations. The self reporting that the refineries do and the DEQ monitoring process appears to be lacking due to numerous causes. This project will empower the average citizen to have a say that will be hard to ignore.
- The first location is on a covered porch so it is protected from the weather and does not have to look thru a window. Power is readily available. Internet is not available since there is no phone line to the structure. Cell coverage is good.
- The second location will be inside looking thru a window at one flare.
Photo by @donblair - pointing a DIY spectrometer from the roof of a building.
We would like you to help with an equipment list, sources, and prices. The first scenario should take more equipment while the second should be a subset of the first.
- WIFI cell hot spot It should have WiFi and an e-net port. It should be about $50/month for one year.
- RaspberryPI Processor for the data capture and transmission. Are there real security concerns connecting this to the Internet?
- Low resolution thermal imaging sensor and interface I am thinking of the 16 pixel MEMS device. This could be used to determine when to take a picture/spectrum along with general temperature measurements.
- Two spectrometers There are 2 flares visible from the location.
- Particle sensor A port of the DustDuino to RPi?
- USB powered hub RPi has low power on the USB port.
The following can probably be lumped together.
- misc. cables
- power supplies
- misc. mounting hardware: a desk vise ($27)
- web Storage
Questions and next steps
We need to raise the money to fund the project. You can help by going to the ioby page and making a contribution.